Exhaust

The headers are Red's Tri-Y's flowing into Summit Racing 2 1/2" Mustang dual exhaust kit. I couldn't use the turbo mufflers that came with the kit to make things fall in position. To resolve this I used center out/off-set in mufflers instead of off-set in/out mufflers.

 To have this kit 'really fit great I should had bend the intermediate pipe to kick up then back out, right before the recess under the back seat so the muffles would fit tighter to the floor pan before it goes over the axle. The tail pipes are a little short because of the over hang length of the Mustang is different that a Falcon.

I preferred not to go with a X or H pipe at this time. I like the sound of un-balance system too much. When I need to find more horsepower, I'll know where to look first.
 

Summit Racing 2.5"exhaust kit for a early Mustang	The ends fit a 3"collector, my collectors are 2.5"	I cut off the old collector end and welded it on the new pipe
	Test fitting the pipes	I bought the center-out to get things to align up closer
Holding up the muffler to get measurements	Here's the left pipe	The right pipe needs a little tweaking to be straight
Mustangs have a shorter rear overhang than a Falcon		Hooker exhaust tip